Compatibility :	3.5.0
Editions :
Platforms :

Used to tell the Wrapper to redirect all of its syslog output to a remote host. The default value is NULL.

wrapper.syslog.remote.host=syslogserver

If the remote host is set, but you are not seeing any log output on the syslog server, please make sure that the wrapper.syslog.loglevel property is set correctly.

Remote syslog messages are sent to the syslog server using the UDP protocol. Because of this, any of the log message will be silently discarded by the syslog server when is not available. It is also possible on slow or complex networks that individual log messages could arrive out of order. The benefit of UDP is efficiency. Problems on the syslog server or network should not affect performance of the Wrapper due to this logging.

• wrapper.syslog.facility (3.2.1)

  Sets the facility code to use when logging to the syslog on UNIX systems.

• wrapper.syslog.ident (3.2.0)

  Sets the identity (or event source on Windows) to use when logging to the syslog.

• wrapper.syslog.ident.enable (3.5.28)

  Ensures whether the event source should exist or not in the Windows registry.

• wrapper.syslog.local.host (3.5.0) ( Std/Pro )

  Specifies the local host name included in the packets sent to a remote syslog.

• wrapper.syslog.loglevel (2.2.5)

  Filters messages sent to the syslog (or event log on Windows) according to their log levels.

• wrapper.syslog.remote.host (3.5.0) ( Std/Pro )

  Specifies the host name of a remote syslog server where log outputs should be redirected to.

• wrapper.syslog.remote.port (3.5.0) ( Std/Pro )

  Specifies the port that the remote syslog server is listening on.

• wrapper.syslog.split_messages (3.5.24)

  Forces messages to be broken up into individual lines making them easier to read.