Linux/UNIX Configuration Properties

Properties on this section which are only used on Linux/UNIX platforms.

• wrapper.daemonize (3.0.0)

  Spawns a fork of the Wrapper process as a detached non-session group leader.

• wrapper.wait_for_hostid (3.4.0) ( Std/Pro )

  Tells the Wrapper to wait for network interfaces at startup.

• wrapper.wait_for_hostid.strict (3.5.41) ( Std/Pro )

  Forces the Wrapper to wait for a specific HostId.

• wrapper.wait_for_hostid.timeout (3.5.41) ( Std/Pro )

  Configures the maximum number of seconds the Wrapper should wait for network interfaces to come up.

• wrapper.signal.mode.hup (3.2.2)

  Configures the action to take place whenever HUP signals are received.

• wrapper.signal.mode.usr1 (3.2.4)

  Configures the action to take place whenever USR1 signals are received.

• wrapper.signal.mode.usr2 (3.2.4)

  Configures the action to take place whenever USR2 signals are received.

• wrapper.ulimit.data.hard (3.5.33)

  Specifies the hard limit for the data segment size.

• wrapper.ulimit.data.soft (3.5.33)

  Specifies the soft limit for the data segment size.

• wrapper.ulimit.data.strict (3.5.33)

  Stops the Wrapper if the limits of the data segment size are not properly configured.

• wrapper.ulimit.loglevel (3.5.31)

  Controls at which log level resource limits will be logged.

• wrapper.ulimit.nofile.hard (3.5.31)

  Specifies the hard limit for the number of file descriptors.

• wrapper.ulimit.nofile.soft (3.5.31)

  Specifies the soft limit for the number of file descriptors.

• wrapper.ulimit.nofile.strict (3.5.31)

  Stops the Wrapper if the limits for the number of file descriptors are not properly configured.