Compatibility :	3.5.21
Editions :
Platforms :

To improve performance, the Wrapper will only flush output written to the log file after a configurable interval. The log file will also be flushed automatically whenever the system output buffer is full.

Possible values are in the range of "0" to "3600" seconds. A value of "0" (zero) will cause the log file to be flushed immediately after each log entry is written to disk.

The default value is "1" second.

wrapper.logfile.flush.timeout=1

In most cases, a value longer than 1 or 2 seconds does not make a lot of sense as any performance gains become insignificant. You also risk losing any unflushed log output in the event of a Wrapper or system crash. Be aware that the log file may also be closed after inactivity which will also flush the log file. See the wrapper.logfile.close.timeout property for more information.

• wrapper.log.lf_delay.threshold (3.5.10)

  Sets a threshold to split JVM messages that would be too long to be printed at once.

• wrapper.log.warning.threshold (3.5.8)

  Prints a warning when a log entry takes longer to be printed than the specified number of seconds.

• wrapper.logfile (1.0.0)

  Sets the path to the Wrapper log file.

• wrapper.logfile.close.timeout (3.5.21)

  Controls the number of seconds at which the log file should close after the last log entry.

• wrapper.logfile.flush.timeout (3.5.21)

  Configures the interval in seconds at which the Wrapper flushes all outputs to the log file.

• wrapper.logfile.format (2.2.5)

  Configures the format of the outputs sent to the log file.

• wrapper.logfile.inactivity.timeout (3.2.0)

  Controls the number of seconds at which the log file should close after the last log entry.

• wrapper.logfile.loglevel (2.2.5)

  Filters messages sent to the log file according to their log levels.

• wrapper.logfile.maxfiles (2.2.5)

  Controls the maximum number of rolled files.

• wrapper.logfile.maxsize (2.2.5)

  Controls the maximum size of rolled files.

• wrapper.logfile.purge.pattern (3.3.8)

  Controls the file pattern to purge old log files.

• wrapper.logfile.purge.sort (3.3.8)

  Configures the sorting mode of the rolled files to purge the last ones.

• wrapper.logfile.rollmode (3.2.0)

  Sets the roll mode of the log file.

• wrapper.logfile.group (3.5.38)

  Specifies the group to assign when creating the log file.

• wrapper.logfile.umask (3.2.0)

  Specifies the umask to use when creating the log file.